Omron HEM-RML30 Blood Pressure Monitor User Manual


 
2
CW Wide Range Cuff (HEM-RML30)
Instructions for use
• Use only the approved Blood Pressure Monitor
for this cuff.
• Do not wash the cuff or make it wet.
1. Put your left arm through the cuff loop.
Note: If the cuff is not assembled, pass the end
of the cuff furthest from the tubing through
the metal D-ring to form a loop. The smooth
cloth should be on the inside of the cuff loop.
2. Position the arm correctly.
1) The air tube should run down the inside of your
forearm and be in line with your middle nger.
2) The bottom of the cuff should be approximately
1 to 2 cm above your elbow.
3) Apply the cuff to your upper arm so that the
marker (arrow under tube) is centered on the
middle of your inner arm and points down the
inside of the arm.
Notes:
• Do not place the cuff over thick clothes and do
not roll up your sleeve if it is too tight.
• Align the cuff with the height of your heart (breast
height). If necessary use a pillow or cushion.
Thank you for purchasing the OMRON Wide Range Cuff. Arm circumference for this cuff is
22 to 42 centimeters. OMRON Wide Range Cuff can be connected to various OMRON Blood
Pressure Monitors. Please refer to the original instruction manual of your Blood Pressure Mo-
nitor. Please check your present product as to which plug you must use. Connect the correct
air plug to the air tube.
1.
2.
Please read this instruction manual thoroughly before using the unit.
Please keep for future reference.
Caution