Filter
Top Products
39
" Select <
OK
> button to save the preference setting in the PC Memory.
" From the preference menu you can also set the header and footer line as you need for later printed report.
" Save model (Save as …) with extension .LMM.
" Now connect the instrument with the communication cable and turn it on.
" Open the file AGC.LMM (if previously closed ).
" Select the <
Data
> command from the menu and then the option <
Save Tag
>. Select for example Tag A and press
the <
Ok
> button.
" Disconnect the unit and go on the field to take same measurements (see also cap.10 to operate in an acquisition
mode).
" Start this procedure with the
OSP
switched -Off-
" Keep the <
MEM
> key pressed and, simultaneously, press the <
Trigger
> until the following indication is displayed :
e
Log
°C
Lock
• Press the <▲> or <▼> key to select the Tag A identification code.
e
Lo
g
°C
Lock
• Press the <
SEL
> key to display the number of memory locations still available.
e
Log
°C
Lock
Data can be recorded in the selected Tag in manual or automatic mode. About the acquisition mode and setting of time
acquisition, refer to par. 9.5.
• If necessary, press the <
SEL
> key to obtain the page that allows the clearing of the previous memory stored data in
the Tag A: