Filter
Top Products
Page of 13
10
10. Be sure to check the condition of the cable every three months, and replace it if the wires are
damaged, twisted, frayed or broken.
Consequently, if the cable needs to be replaced, it can be secured using U-bolt
clamps suitably proportioned to the diameter of the cable itself, as indicated in
the diagram.
Only during primary operation, the manufacturer shall use a special aluminum
coupling for the assembly. However, this requires the use of specific equipment.
As with all maintenance work, replacement of the cable and the relative clamps
must be carried out by specialized personnel.
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List are included. If any
parts are missing or broken, please call Northern Tool + Equipment Customer Service at
1-800-222-5381.
MAINTENANCE
WARNING: Make sure this tool is disconnected from its power source before attempting
any maintenance, cleaning, or inspection.
• Maintain your tools. It is recommended that the general condition of any tool be examined
before it is used. Keep your tools in good repair by adopting a program of conscientious repair
and maintenance in accordance with the recommended procedures found in this manual. If any
abnormal vibrations or noise occurs, turn the tool off immediately and have the problem
corrected before further use. Check cable for tears excessive wear, frays or other types of
damage. Have necessary repairs made by qualified service personnel.
• Cleaning. Use only soap and a damp cloth to clean your tools. Many household cleaners are
harmful to plastics and other insulation. Never let liquid get inside a tool.
• Check for misalignment or binding of moving parts, breakage of parts, and any other
condition that may affect the tool’s operation. If damaged, have the tool serviced before using.
Many accidents are caused by poorly maintained tools.
• Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on another
tool.