Filter
Top Products
FIGURE 2
ASSEMBLY AND OPERATING INSTRUCTIONS
Hoist Set-up
WARNING!
Unplug the Hoist before set-up.
1. This Hoist is designed to be attached to a beam or steel pipe and bed securely
held in place by both of the Hangers (#23). See FIGURE 2.
Note: The beam or steel pipe must be capable of carrying several times the weight of
the Hoist and its designated maximum capacity. If in doubt, consult a registered
engineer and building code.
Note: Make sure the area underneath or around the Hoist is clear of obstructions. Do
not Hoist loads over people or animals.
2. After determining the location of the Hoist, make sure the beam or pipe is the
proper size to fit inside of the Hangers (#23). Have a second person hold the top of
the hoist flush against the beam or pipe. Line up the holes on each Hanger (#23) with
the holes on the top of the Hoist. Thread in the two Screws (#21) and Washers (#20)
per Hanger (#23) to secure the Hoist to the Beam or Steel Pipe. Check that it is
secure. Before each use, check that the Hangers (#23) are securely fastened to the
Hoist.
3. Ideally, the Hoist needs to be set-up within a reachable distance to a 3- prong
power outlet without the need of an extension cord. However, extension cords are
safe and acceptable when properly used.
PAGE 10