Filter
Top Products
MIX N' GO MIXER — OPERATION & PARTS MANUAL — REV. #5 (11/07/05) — PAGE 19
MIX N' GO MIXER — ASSEMBLY INSTRUCTIONS
Assembly
1. Remove the mixer drum and associated components from
the packing container (Figure 6). Match the components
against the parts list to make sure that they are all accounted
for.
Figure 6. Packing Container
4. Place the two halves of the optional support stand together
(Figure 9). The left support stand fits into the center boss on
the right support stand.
5. Insert the adapter pin through bosses as shown in Figure 9.
Once the adapter pin has been inserted and aligned, insert
the locking pin. Place the round part of the locking pin over
the bottom section of the adapter pin.
2. Place the mixer frame on a secure level surface, and attach
the top cover as shown in Figure 7.
3. Fit the mixing drum onto gearbox shaft as shown in Figure
8. Rotate drum in a clockwise direction, make sure the drum
fits right up to the shoulder on the gearbox shaft.
Figure 7. Top Cover Placement
Figure 8. Mixing Drum Placement
Figure 9. Optional Support Stand
DO NOT
spin
the drum on
fast
, as this may
damage the gearbox.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION