Filter
Top Products
INSTALLATION INSTRUCTIONS
2
INSTALLATION OF SHROUD ASSEMBLY
1. Apply 1/4” bead of plumber’s putty (not supplied) around lower
flange of spray nozzle assembly. Hand tighten spray nozzle
shroud onto spray nozzle assembly.
CAP
HANDLE SCREW
HANDLE
CARTRIDGE NUT
ESCUTCHEON NUT
ESCUTCHEON
TRIM RING
DIVERTER VALVE
Shroud
Pop up head piece
O-ring
Seat cover
Seat
INSTALLATION OF WASTE TRIM
1. Place seat cover into waste tube and push carefully down. Be careful not to
bend seat cover.
2. Screw pop-up head piece firmly onto base part. Be careful not to cross
thread the part. Ensure that o-ring is correctly seated on head piece.
INSTALLATION OF LIFT ROD ASSEMBLY
1. Thread mounting tube into the lift rod escutcheon. Place
the rubber washer below the lift rod escutcheon.
2. Insert the mounting tube through the bidet lift rod hole
from above. Place the metal washer on the mounting
tube. Thread the mounting nut onto the mounting tube
and tighten.
3. Hook-up lift rod, and lift and pivot assembly to pivot rod as shown and tighen
screws.
4. With drain plug in full open position, and the lift rod down, adjust the lift and pivot
assembly for proper operation.Test lift rod action to make sure it operates freely.
NOTE: If the lift rod or pivot rod binds against the “TEE”connection carefully bend
the inlet and discharge tubes slightly outward to clear lift rod.
In order to remove seat cover, use screwdriver to
bend snap features back from the inside as
shown in picture. Do not try to lift seat cover with
tool from outside.
Mounting Nut
Lift Rod Escutcheon
Mounting Tube
Metal Washer
Rubber Gasket
Lift rod knob
Lift rod
Lift and pivot
assembly
Gasket
Nut
Steel washer
Pivot rod
Escutcheon
Waste assembly
Correct Disassembly Incorrect Disassembly
INSTALLATION OF DIVERTER TRIM
1. Remove cartridge nut and escutcheon nut from diverter valve.
2. Slide trim ring over diverter valve so that trim ring sets flat against bidet deck.
3. Place escutcheon over divertrer valve.
4. Install and lightly tighten escutcheon nut. Install and firmly tighten cartridge
nut.
5. Place handle on diverter valve stem and secure with handle screw.Press cap
into place on handle