Filter
Top Products
113
CHAPTER 5 ACCESS BETWEEN CPU MODULES AND OTHER MODULES
5
5.3 Access From a Programming Tool
(2) Access to controlled and non-controlled modules
A programming tool can access modules both controlled and not controlled by the QCPU connected.
The programming tool connected to one QCPU can access all the modules controlled by any QCPU in the
multiple CPU system.
The programming tool can also access QCPUs on other stations in the same network such as CC-Link IE,
MELSECNET/H, or Ethernet.
1 1 1
222
A programming tool can access all modules in the system.
Slot number
Control CPU setting
CPU 0 1 2 3 4