Melissa 235-013 Styling Iron User Manual


 
20 21
20 21
Start with a lock of hair about 5
cm wide and close the ceramic
plates around the hair near the
scalp. Avoid touching the scalp
with the hot appliance.
Slowly slide the appliance
towards the hair ends in a uent
movement. Keep the hair tight to
avoid kinks. For more lift in the
hair, smooth only the outer part
of the hair lock.
Finish off by either curling the
hair ends inwards or outwards
for a curled or bobbed look.
Alternatively, wrap the lock of
hair around the appliance and
hold it there for a few seconds
for loose curls.
CLEANING
Remove the plug from the wall
socket and allow the appliance
to cool down before cleaning.
Never submerge the appliance
in water, and no water must be
allowed to get into it.
Do not use scouring sponge,
strong or abrasive cleaning
agents, solvents or similar to
clean the appliance, as these
may scratch or damage the
external surfaces and the
ceramic plates. Wipe it with a
well-wrung soft cloth.
INFORMATION ON DISPOSAL
AND RECYCLING OF THIS
PRODUCT
Please note that this Adexi
product is marked with this
symbol:
This means that this product must
not be disposed of together with
ordinary household waste, as
electrical and electronic waste must
be disposed of separately.
In accordance with the WEEE
directive, every member state must
ensure correct collection, recovery,
handling and recycling of electrical
and electronic waste. Private
households in the EU can take used
equipment to special recycling
stations free of charge. In some
member states you can in certain
cases return the used equipment
to the retailer from whom you
purchased it, if you are purchasing
new equipment. Contact your
retailer, distributor or the municipal
authorities for further information on
what you should do with electrical
and electronic waste.
GUARANTEE TERMS
The guarantee does not apply:
if the above instructions are not
followed
if the appliance has been
interfered with
if the appliance has been
mishandled, subjected to rough
treatment, or has suffered any
other form of damage
If faults have arisen because of
faults in your electricity supply.
Due to the constant development
of our products in terms of function
and design, we reserve the right
to make changes to the product
without warning.