Filter
Top Products
TEST MODE
If the POWER button is held down too long (approximately 2
seconds), the display will enter TEST MODE or the Power
will turn off. In either case, press the POWER button twice to
restart the measurement.
ERROR DISPLAY
The Error Display symbol, Fig. A, will appear for the following:
1) Noise, movement or talking during measurement.
2) Inadequate pressure for cuff inflation due to movement or
talking during measurement.
3) Wrist cuff improperly applied (too tight, too loose,
improper position).
RECALLING MEASUREMENTS IN MEMORY
Recall up to 30 measurements in each memory bank.
Make sure you’ve selected the proper Memory Bank for the
reading to be viewed. See Memory Select under “Features”.
19
Fig. A.