11
Setting the Time:
1. Insert an unfolded paper clip into the ‘SET’ hole to enter Set mode. The
small hole is located just below the receptacle for the AC adapter on the right
side of the 1157.
2. The four digit year in the display should start blinking. Press Page>
to advance the year, and <Page to decrease it.
3. Press the Start/Stop button once the year is correct. The hour
should start to blink. Again use the <Page and Page> buttons to adjust the
hour.
4. Press the Start/Stop button once the hour is correct. The minutes should
start to blink. Again use the <Page and Page> to adjust the minutes.
5. When the date and time is correct, press the Power button to return
to normal mode.
‘SET’ Hole
1157-IM-bilingual.indd 11 3/11/05 10:59:44 AM