LifeSource UA-853 Blood Pressure Monitor User Manual


 
E-4
LifeSource Health Line (Toll-Free): 1-888-726-9966
You must install 4 type AA (1.5 volt) batteries (alkaline batteries
recommended), or use the AC Adapter (see page E-14 for using the Monitor
with AC Adapter) and attach the cuff to the monitor before using it. To install
batteries (or replace them if the “Low Battery” symbol appears on display),
proceed as follows:
1. Remove battery compartment cover by gently
pushing down on arrow and sliding cover forward.
2. Put in bottom row of batteries first. Place the
batteries in compartment with positive (+) and
negative (–) terminals matching those indicated in
the compartment. Be sure batteries make contact
with compartment terminals.
3. Replace cover by sliding it into the compartment and gently pressing into
place.
NOTE: Rechargeable batteries will not work with this monitor.
LifeSource® blood pressure monitors are easy to use, accurate and digitally
display full measurement readouts. Our technology is based on the
“oscillometric method” – a noninvasive blood pressure determination. The
term “oscillation” refers to any measure of vibrations caused by the arterial
pulse. Our monitor examines the pulsatile pressure generated by the arterial
wall as it expands and contracts against the cuff with each heartbeat.
The cuff is inflated until the artery is fully blocked. The inflation speed is
maximized and the pressure level is optimized by the device. The monitor
takes measurements while the cuff is both inflating and deflating. This results
in a faster measurement providing greater comfort to the user.
AM/PM TimeWise™ Technology
This monitor automatically stores each measurement as an AM or PM reading
in memory (note: clock must be properly programmed before initial use).
Healthcare providers agree that understanding your AM and PM readings can
assist in the proper diagnosis and management of your heart health through
lifestyle and/or medication modifications.
HOW UA-853 WORKS
?
BEFORE YOU START
?!
Step 1
Step 2
Step 3