Filter
Top Products
Leica M series Manual 38
IsoPro™ Motorized Cross-stage: Assembly (continued)
The bases
The TL BFDF, TL RC™ and RCI™ transmitted light
bases can be equipped with three different
stages: standard stage, manual and IsoPro™
automated cross-stage. The selected stage is
mounted on the base before commissioning.
You can switch between the stages at any time
with just a few hand movements.
The following paragraph assumes use of the
base without the stage mounted. Disassembly
is performed in reverse order of the following
steps.
Cross-stage and base
Never move the sledge of the motorized
cross-stage manually in the X direction,
as otherwise the mechanical system will be
damaged!
1. Place the cross-stage on the base.
2. Pull the upper part of the cross-stage care-
fully toward the user, fastening the lower
part onto the transmitted-light base.
3. Screw the cross-stage evenly onto the three
threaded holes.
4. Push the cross-stage all the way back
towards the column.
5. Reinsert the glass plate back into the stan-
dard stage.