Filter
Top Products
17
humidity, and the time as 12:00 will be displayed. If they are not
shown in LCD after 60 seconds, remove the batteries and wait for at
least 60 seconds before reinserting them.
4. The outdoor temperature from the first sensor (channel 1) should then
be displayed on the Wireless Temperature Station. If this does not
happen and the signal reception icon is not shown, after 2 minutes, the
batteries will need to be removed from both units and reset from step 1.
5. Insert the batteries to the second sensor as soon as the outdoor
temperature readings from the first sensor are displayed on the
Wireless Temperature Station.
NOTE: You must insert the batteries into the second sensor within
10 seconds of reception of the first sensor.
6. The outdoor temperature from the second sensor and the "channel 2"
icon should then be displayed on the Wireless Temperature Station. If
this does not happen after 2 minute, the batteries will need to be
removed from all the units and reset from step 1.
7. Insert the batteries to the third sensor as soon as the "channel 2" icon
and outdoor data are displayed on the Wireless Temperature Station.
Then within 2 minutes, the channel 3 outdoor data from the third
sensor will be displayed and the channel icon will shift back to "1"
once the third sensor is successfully received. If this is not happen, user
shall restart the setting up from step 1.
NOTE: You must insert the batteries into the third sensor within 10
seconds of reception of the second sensor.
IMPORTANT: Transmission problems will arise if the setting for
multiple sensors is not followed as described above. Should
transmission problems occur, it is necessary to remove the batteries
from all units and start again the set-up from step 1.
V. VIEWING AND OPERATING WITH MULTIPLE REMOTE
TEMPERATURE SENSOR UNITS
1. To view the temperature of a different remote temperature sensor
unit, press and release the CH button. A shift from one “boxed”
number to the next should be observed in the OUTDOOR LCD.
2. To view the Minimum/Maximum temperature: first select which
remote temperature sensor to read data from (indicated by the
“boxed” number), then press the OUT button. Pressing this button