Filter
Top Products
5. If no weighing process takes place, the scale switches off
automatically after 60 seconds.
ᕨ Establishing body fat and water contents
In order to establish your body fat and water contents you must have previously stored your personal
data (see Chapter 6).
1. Remove the remote control from the scale. Press the key
U to switch on the remote control. The running display
“bALAnCE“ appears on the display above the line, the
display “---- kg” appears below the line.
2. Gently touch the scale with your foot. The red LED display
lights up. The running display “bALAnCE” appears on the
display above the line, and the display “---- kg” below the
line. After approximately 2 seconds the green LED display
lights up and “0.0kg” appears on the display below the
line. The scale is now ready for operation.
3. Press the key i to select the unit kg or lb.
The following alternative measuring methods are available:
ᕨ a) Weighing with subsequent establishment of body fat and water contents
1. Step on the scale for weighing.
Note: Stand on the metal contacts without shoes or stok-
kings. Your feet must be clean and dry when you step on
the scale. However, very dry feet can affect the measure-
ment. In this case, moisten your feet with a moist cloth and
repeat the measurement.
2. As soon as the weight has been established the display
“H” appears as described in Chapter 7. Press the keys “^”
or “v” to select your pre-programmed storage place (1-10)
and confirm by pressing the key i
3. For control purposes, the stored settings “Sex and Age”
followed by “Sex and Size” of the selected storage place
are shown on the display for control purposes.
8
RZ_IB_Köfett_LB4 22.09.2003 11:22 Uhr Seite 8