Filter
Top Products
5
115982-2-BA (-)
Kohler Co., Kohler, WI
2. PRODUCT NOTICES
A. INSTALLER HAZARD NOTIFICATION
DANGER: Risk of fire, electric shock, or injury
to persons. Read important safety instructions on
inside front cover of these instructions.
WARNING: Risk of electrical shock. A licensed
electrician should make all electrical connections.
WARNING: Risk of electrical shock. Connect
only to a circuit protected by a Ground-Fault
Circuit-Interrupter (GFCI).
WARNING: Risk of electrical shock. Disconnect
power before servicing.
WARNING: Risk of injury or property damage.
Please read all instructions thoroughly before
beginning installation, including the following
Product Requirements.
NOTICE: Follow all local plumbing and electrical
codes.
B. FACTORY-ASSEMBLED FEATURES
Factory installed components include pump with integral
heater, control, and switch. No installation is needed.
The whirlpool pump and piping are factory-assembled.
WARNING: Unauthorized modification may
cause unsafe operation and poor performance
of the whirlpool. Do not relocate the whirlpool
pump, or make other modifications to the whirlpool
system, as this could adversely affect the
performance and safe operation of the whirlpool.
Kohler Co. shall not be liable under its warranty or
otherwise for personal injury or damage caused by
any such unauthorized modification.
3. PRODUCT REQUIREMENTS
A. SUMMARY OF KEY REQUIREMENTS
S Install unit to a level subfloor.
S Provide properly dimensioned framing.
S Recess installation is recommended.
B. PLUMBING SPECIFICATIONS
Confirm adequate mounting and connection space of
the faucet specified for your installation.
Confirm adequate support for the faucet; large faucets
that may be inadvertently used as a means of support
are not appropriate or safe for this installation.
In locations where plumbing is adjacent to a masonry
wall, make provisions for access to the connections.
Construct a separate wall a minimum of 6” from the
masonry wall. Install furring when the back of the unit is
against the masonry wall.
Because this is a one-piece unit, drain and overflow
connections cannot be made by reaching over the end
of the bath. Before installation, provide access to the
connections. See the Plumbing Access Considerations
section located on Page 8.
C. PRODUCT INSPECTION
Carefully unpack the whirlpool, remove the protective
tape, and and inspect the unit for damage. Leave all
materials in the carton during construction to prevent
damage.
NOTICE: Make sure both union connections to the
pump are securely tightened.
D. CONNECTIONS AND SERVICE ACCESS
Before installation, ensure proper access to the final
connections.
NOTICE: Provide unrestricted service access to the
pump. An access panel must be constructed to allow for
sufficient clearance for servicing the pump or controls.
The access panel must be located at the pump end of the
whirlpool.