Filter
Top Products
6. Position the Unit
CAUTION: Risk of product damage. Do not lift or support the unit by the pump or piping.
With help, carefully lift the unit into place.
Cut and discard the banding straps from the pump.
Insert the drain tailpiece into the trap.
7. Install the Plumbing
CAUTION: Risk of property damage. Ensure a watertight seal on the drain connections.
IMPORTANT! Choose a fill spout which will provide adequate air space above the bathing well rim of the
unit. You may need to build up the deck material to obtain adequate air space because the outer rim may
be lower than the bathing well rim. In addition, if you plan to install a deck-mounted, hand-held shower,
the diverter vacuum breaker must maintain a minimum 1″ (2.5cm) air gap above the outer rim.
NOTE: An access panel must be installed for future maintenance.
If you have not yet done so, connect the drain to the trap according to the drain manufacturer’s
instructions.
Install the faucet valving according to the faucet manufacturer’s instructions. Do not install the faucet trim
until instructed.
Make sure all supply connections are tightened securely.
Open the hot and cold water supplies, and check the supply connections for leakage.
Run water into the bathing well, and check the drain connections for leakage.
Drainage
Suction Line
Banding
Straps
Pump
Suction Line
Drainage
2" MIN.
Inner Rim
Outer Rim
Bathing Well
(5.1cm)
1012493-2-A 8 Kohler Co.