Filter
Top Products
FCC Compliance
FCC ID : N82-KOHLER001
Canada ID : 4554A-KOHLER001
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for compliance could void the
users authority to operate the equipment.
Remote Control
The remote control places the whirlpool functions at your fingertips to further enhance your bathing
experience. The functions of the remote are identical to the user keypad. You may turn the whirlpool on and
off, increase or decrease the volume of the water flow (when the Flexjet mode is active), turn the
chromatherapy lights on and off, turn the heater on and off, and select a specific chromatherapy color with
the press of a button on the remote control keypad.
The mode selector button functions in the same way as the outer ring on the keypad. When ″M″ is pressed,
one of the modes will flash on the user keypad. If ″M″ is pressed again, the next mode in clockwise order
will flash. When the desired mode is flashing, press ″OK″ to activate it.
When the Flexjet mode is active, the arrows will increase or decrease the water flow volume.
The waterproof remote control is designed to be used in the bath and will float in the water.
Two AAA batteries are used in the remote control. To replace, simply unscrew the endcap and insert the
batteries, as shown above. Tighten the endcap securely, making sure the endcap makes contact with the
seal.
Programming the Remote Control
NOTE: Programming of the remote control is not required. However, if more than one device in your
home or in the near vicinity of your home uses a remote control, it may be necessary to program this
remote control to the user keypad. If you replace your remote control or replace the pump control, it may
be necessary to program the remote control.
Activates
Mode
Selected
Power
Increases
Flow or
Pulse
Mode
Selector
Decreases
Flow or
Pulse
1042951-5-B 8 Kohler Co.