Support User Manuals

Invacare XLT Mobility Aid User Manual

Open as PDF

of 76

SECTION 7—WHEELS

Recumbent Handcycle Series 42 Part No 1114850

SECTION 7—WHEELS

ƽ WARNING

After any adjustments, repair or service and before use, make sure all attaching

hardware is tightened securely - otherwise injury or damage may result.

Installing/Adjusting the Rear Wheel and Quick-Release

Axles

NOTE:Forthisprocedure,refertoFIGURE 7.1.

1. Makesurethattheaxlereceiverhexnut

issecurelytightenedbeforeinstalling

therearwheels.

2. Depressdetentpininthequick‐release

axleandslideaxlethroughtheaxle

receiver.

3. Releasedetentpinensuringthatthe

lockingpinsarefullyreleased.

NOTE:LockingpinsMUSTprotrudepastthe

endoftheaxlereceivertofullyrelease.Any

excessiveplayMUSTalsobeeliminated.

FIGURE 7.1 Installing/Adjusting the Rear

Wheel and Quick-Release Axles

4. Increaseordecreaseendplaybyadjustingthelocknutontheendofthequick‐release

axle.

ƽ WARNING

Make sure detent pin is fully released before operating the handcycle.

Keep locking pins clean.

5. Reinstallrearwheelonthehandcycle.

6. Tilthandcycleontoeitherrearwheelandspinraisedwheel.Itshouldspinfreelywith

noexcessivedrag.

7. Repeatprocedureforoppositerearwheel.

NOTE:Ifdragtoeithersideoccurs,repeattheprocedureuntilthehandcyclerollscorrectly.

Axle Receiver

Hex Nut

Quick-release

Axle

Locknut

Locking

Pins

Axle Receiver

Detent

Pin

previous next