Invacare 1610 Mobility Aid User Manual


 
FIGURE 5 - ASSEMBLY OF THE FRONT X-BRACE
Top View
Front of Seat
Spacers
Slide X-Brace Over Seat Rails
Spacers
Seat Rails
4
Solid Seat Ordered Off Chair (FIGURE 6)
1. Remove wheelchair arms.
2. Close chair.
3. Remove the ten (10) mounting screws securing the
seat upholsteryto the seat rails.
4. Remove the two (2) X-brace pivot screws and lock-
nuts from X-brace.
5. Lift one (1) seat rail UP until the two (2) seat guides
are clear of the guide tubes.
6. Remove the end cap, rear seat guide and EXISTING
spacer. Discard EXISTING spacer.
7. Repeat STEPS 5-6 on remaining seat rail.
8. Slide one (1) NEW short spacer, solid seat brace, rear
seat guide, and end cap onto the right seat rail and
secure with two (2) tap screw as shown in FIGURE 6.
9. Slide one (1) NEW medium spacer, solid seat brace,
rear seat guide, and end cap onto the left seat rail and
secure with two (2) tap screw as shown in FIGURE 6.
10. Insert the four (4) seat guides into the four (4) seat
guide tubes.
NOTE: Ensure only 1/8-inch of the pivot bolt threads ex-
tend beyond the end of the locknut.
11. Reinstall the two (2) X-brace pivot screws and lock-
nuts.
12. Slide a long spacer and solid seat brace onto the right
side seat rail and secure with tap screw as shown in
FIGURE 6.
13. Slide a long spacer and solid seat brace onto the left
side seat rail and secure with tap screw as shown in
FIGURE 6.
14. Secure the solid seat insert to the two (2) left solid
seat brackets with the four (4) long mounting screws.
NOTE: When connecting the right and left solid seat brack-
ets, tighten the bolts and locknuts enough to minimize
play, but still allow the solid seat braces to pivot when fold-
ing the wheelchair.
15. Secure the two (2) left solid seat braces to the two (2)
right solid seat braces with the two (2) bolts and lock-
nuts.
INSTALLING THE SOLID SEAT -
TRACER IV ONLY (FIGURE 6)
NOTE: Refer to the GENERAL WARNINGS in the
SAFETY SUMMARY of this Instruction Sheet.
NOTE: Right and Left sides of the wheelchair are de-
termined from the occupants position.
NOTE: Take note of orentation and position of seat
end caps and hardware for reinstallation.
Solid Seat Ordered On Chair (FIGURE 6)
1. Remove the two (2) tap screws that secure the front
solid seat braces to the seat rails.
2. Remove the front solid seat braces from the seat rails.
Rotate the front solid seat braces upward and reinstall
onto the seat rails and secure with the two (2) tap screws
provided as shown in DETAIL "A" of FIGURE 6.
3. Remove the two (2) bolts and lock nuts that secure
the two (2) right solid seat braces to the two (2) left
solid seat braces.
4. Secure the solid seat insert to the two (2) left solid
seat brackets with the four (4) long mounting screws.
NOTE: When connecting the right and left solid seat brack-
ets, tighten the bolts and locknuts enough to minimize
play, but still allow the solid seat braces to pivot when fold-
ing the wheelchair.
5. Secure the two (2) left solid seat braces to the two (2) right
solid seat braces with the two (2) bolts and locknuts.