Invacare RLS6 Scale User Manual


 
NOTE: The Reliant Scale CANNOT be used in conjunction with the swivel bar supplied with the
Invacare 9805 Lift. The Reliant Swivel Bar (Part No. 1064518) MUST be purchased and
installed on the Invacare 9805 lift in order to install the Reliant Scale.
NOTE: Check all parts for shipping damage before using. In case of damage, DO NOT use the
equipment. Contact the Dealer/Carrier for further instructions.
SAFETY SUMMARY
GENERAL WARNINGS
DO NOT install or use this equipment without first reading and
understanding these instructions. If you are unable to understand the
Warnings, Cautions or Instructions, contact a healthcare professional,
dealer or technical personnel before attempting to install this equipment
- otherwise, injury or damage may occur.
The weight capacity is limited to the lowest rated capacity of any one of
the components in use (i.e. Patient Lift, Sling or Scale). The patient's
weight MUST NOT exceed the lowest rated capacity of any component.
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage
may occur.
Patient and sling MUST be removed from the lift during ALL installation
procedures.
RELIANT SCALE RLS6
Assembly, Installation and Operating Instructions
SAVE THESE INSTRUCTIONS
Reliant Scale 1 Part No. 1114832 Rev B
This kit contains the following:
DESCRIPTION QTY
Load Cell Assembly 1
Nylon Washers 2
Swivel Bar Pin 1
Locknut 1
Mounting Screw 1
Small Steel Washer 1
1/8-inch thick nylon washer (9805 lift) 2
1/4-inch thick nylon washer (450/600 lb lift) 2