Support User Manuals

Invacare R121 Mobility Aid User Manual

Open as PDF

of 52

INSTALLATION

Part No. 1145810 19 Electric Portable Patient Lift

7. Aligntheholesoftheboomassemblymountingbracketwiththoseoftheboom

actuatorandinsertthebolt.Securewithnut.

NOTE:Besurethattheboltiscompletelythroughtheholesoftheboomassemblymounting

bracketandtheactuatorassembly.Theboomassemblywillpivoteasilyifthemountinghardware

isalignedproperlywhentheboomassemblyissecuredtothemast.

CAUTION

DO NOT overtighten the nut and bolt. This damages the mounting bracket.

NOTE:Thebottomoftheactuatorassemblywi llalr eadybeassembledtothemas tmountingbracket.

Installing the Leg Actuator to the Base

NOTE:Forthisprocedure,refertoFIGURE 2.4onpage20.

1. Slidethelegactuatorintotheslotinthebaseofthepatientlift.SeeDetail“B”.

2. Performthefollowingtosecurethelegactuatortothepivotbracket(Detail“A”):

ƽ WARNING

Ensure that there is sufficient room to turn patient lift on its side and that floor area

is clear of debris. Otherwise, injury to personnel or damage to patient lift may

occur.

A. Turnthepatientliftonitsside.

B. Positionslotinlegactuatoroverthepivotbracket.

C. Installthepinthroughthelegactuatorandpivotbracketandsecurewithhitchpin.

D. Returnthepatientlifttotheuprightposition.

3. Performthefollowingtosecurethelegactuatortothemastbracket(Detail“B”):

A. Positionlegactuatorbetweenmastbrackets.

B. Movethelegstoaligntheholesinthelegactuatorwiththeholesinthemast

bracket.

C. Installthepinthroughtheholesofthelegactuatorandmastbracketandsecure

withhitchpin.

4. Plugthependantcontrol(notshown)intothebottom

ofthecontrolbox.

previous next