Filter
Top Products
Invacare® Matrx® Stabilite™Cushion 6 Part No 1167615
3.3 Removing/Installing the ThinAir Bladder
Removing the ThinAir Bladder
1. Remove cushion from inner and outer
covers. Refer to Removing/Installing the
Cushion Covers on page 5.
2. Unfasten the the rear strap and the two side
straps.
3. Lift the existing ThinAir bladder and remove it
from the cushion.
Installing the ThinAir Bladder
1. Center the ThinAir bladder on the foam so
that the side straps are centered in the
contours on each side of the foam.
2. Fasten the side straps and rear strap to the
bottom of the foam.
3. Reinstall cushion into inner and outer covers.
Refer to Removing/Installing the Cushion
Covers on page 5.
3.4 Removing/Installing Removable Leg Wedges
1. Remove the cushion from the inner and outer covers. Refer to Removing/Installing the Cushion
Covers on page 5.
2. Remove the leg wedge from the side of the cushion that requires a lower seat to floor height. Save
the leg wedge for future use.
3. Install cushion into inner and outer covers. Refer to Removing/Installing the Cushion Covers
on
page 5.
Side Strap
Foam Contour
Cushion
Foam Contour
ThinAir Bladder
Rear Strap
Side Strap
DO NOT over-tighten the straps. The
ThinAir bladder MUST be free to move
with the cushion.
This procedure provides 1-inch of lower seat to floor height on one side of the cushion. This
modification allows for easier foot propelling or the accommodation of some hip flexion
limitations.
This modification can be done on either side of the cushion.
Leg wedges secure in place with hook and loop strips.
Top of Cushion
Bottom of Cushion
Hook and Loop Strips
Removable Leg
Wedges