Filter
Top Products
Part No 1167615 5 Invacare® Matrx® Stabilite™Cushion
3.2 Removing/Installing the Cushion Covers
Removing the Cover
1. Remove the cushion from the seating
surface. Refer to Attaching/Removing the
Cushion To/From the Seating Surface on
page 3.
2. Unzip the outer cover.
3. Remove cushion, still inside the inner cover,
from the outer cover.
4. Unzip the inner cover.
5. Remove the cushion from the inner cover.
Installing the Cover
1. If the inner cover has been removed,
position the cushion with the ThinAir
bladder toward the rear of the inner cover.
2. Slide the cushion into the inner cover.
3. Zip the inner cover closed.
4. Position the cushion with inner cover and the
ThinAir bladder in place toward the rear of the
outer cover.
5. Slide the cushion into the outer cover.
6. Zip the outer cover closed.
7. Reattach cushion onto seating surface. Refer to
Attaching/Removing the Cushion To/From the
Seating Surface on page 3.
ƽ
WARNING
The covers are designed to protect the foam from moisture and to provide fire retardency. DO
NOT use the cushion without either the inner or outer cover. If the covers are torn, they MUST
be replaced IMMEDIATELY.
Cushion
Cover
Zipper
ThinAir Bladder
ƽ
CAUTION
DO NOT remove both the outer cover
and inner cover at the same time,
otherwise damage to the inner cover
material may occur.
The back surface of the cushion is
marked “REAR”.
When installed properly, the ThinAir
bladder is at the top of the inner cover.
The zipper is at the rear and the stretch
fabric is at the top of the outer cover.
ƽ
CAUTION
Use care not to snag the inner cover in
the outer cover zipper, or damage to
the inner cover will occur.