Invacare IISTANDARD Wheelchair User Manual


 
38
S
H
R
O
U
D
S
PROCEDURE 9 SHROUDS
This Procedure Includes the Following:
Removing/Installing Shrouds
REMOVING/INSTALLING SHROUDS
MWD Wheelchairs (FIGURE 1)
REMOVING FRONT SHROUD.
1. Turn the two (2) 1/4-turn bolts that secure front shroud
to the two (2) side shrouds COUNTERCLOCKWISE.
2. Remove the front shroud from the wheelchair.
INSTALLING FRONT SHROUD.
1. Position the two (2) 1/4-turn bolts with the two (2) mount-
ing holes in the side shrouds.
2. Install the front shroud onto the two (2) side shrouds.
3. Turn the two (2) 1/4-turn bolts that secure the front
shroud to the two (2) side shrouds CLOCKWISE.
WARNING
After ANY adjustments, repair or service and BE-
FORE use, make sure all attaching hardware is
tightened securely - otherwise injury or damage
may result.
REMOVING REAR SHROUD AND REAR
STORAGE COMPARTMENT.
1. Lift up on rear shroud and remove from wheelchair.
2. Turn the two (2) 1/4-turn bolts that secure the rear stor-
age compartment to the wheelchair frame COUNTER-
CLOCKWISE.
3. Remove rear storage compartment from wheelchair.
INSTALLING REAR SHROUD AND REAR
STORAGE COMPARTMENT.
1. Position the two (2) 1/4-turn bolts with the two (2) mount-
ing holes in the wheelchair frame.
2. Install rear storage compartment onto chair frame.
3. Turn two (2) 1/4-turn bolts that secure the rear storage
compartment to the wheelchair frame CLOCKWISE.
4. Position rear shroud on the two (2) side shrouds and
slide towards the front of the wheelchair until it stops.
5. Press down on the rear shroud until the two (2) clips
secure the rear shroud to the two (2) side shrouds.