Filter
Top Products
86
Repairing the flat tyre
• Unscrew valve cap.
• Depressurise tyre by pressing in the pin in the valve .
• Remove the 5 cylinder head screws (back of the
wheel, 2.
• Remove the rim halves from the tyre.
• Remove the inner tube from the tyre.
• Repair inner tube and replace, or insert new.
NOTE:
If the old inner tube is to be repaired and re-used, and has become wet during repair, you can
make replacement easier by sprinkling the inner tube with a little talcum powder.
• Insert the wheel rim halves from outside into the tyre.
• Pump a little air into the inner tube.
• Insert the cylinder head screws in the rim and tighten the wheel rims firmly.
• Ensure that the tyre outer is seated correctly.
• Pump the tyre up to the prescribed pressure.
• Check that the tyre is seated correctly once again.
• Screw the valve cap back on.
• Refit the wheel.