Filter
Top Products
59
8.5 The Lifter
The electric lifter is operated via the remote. Please see chapter "Operating the electric
adjustment options" on page 42.
Please note – Speed restriction
The lifter is equipped with sensors that reduce the drive speed of the wheelchair as soon as the
lifter is raised or lowered above a certain point.
This is in order to guarantee the tilt stability of the wheelchair or in order to avoid damage to the
legrests.
When speed restriction is activated an appropriate blinking code is displayed on the remote.
Please see chapter "ON/OFF diode (status display)" on page 37 and chapter "Error codes
and diagnostic codes" on page 46.
In order to revert to normal drive speed move the lifter to drive height: Raise the lifter slowly if the
lifter has been lowered. If the lifter has been raised, lower the lifter until the status display stops
blinking.