Invacare 9153644018 Mobility Aid User Manual


  Open as PDF
of 4
 
Adjusting Footrest Height
NOTE: For this procedure, refer to FIGURE 3.
1. Remove the front rigging assembly. Refer to Installing/Removing the Front Rigging
Assembly on page 3.
2. Remove the hex screw and coved spacer.
3. Move the footrest with slide tube up or down on its mounting tube until the desired
footrest height is achieved.
4. Install the hex screw and coved spacer through the front rigging upper support and
the slide tube. Securely tighten.
5. Install the front rigging assembly. Refer to Installing/Removing the Front Rigging
Assembly on page 3.
6. Repeat STEPS 1-5 for the other side, if necessary.
FIGURE 3 Adjusting Footrest Height
Footrest
Slide Tube
Coved Spacer
Hex Screw
Front Rigging
Upper Support
Invacare Corporation
www.invacare.com
USA
One Invacare Way
Elyria, Ohio USA
44036-2125
800-333-6900
Canada
570 Matheson Blvd E Unit 8
Mississauga Ontario
L4Z 4G4 Canada
800-668-5324
Invacare is a registered trademark of
Invacare Corporation.
Yes, you can. is a trademark of Invacare
Corporation
© 2005 Invacare Corporation
Part No 1130250
Rev A - 06/05
 previous