Filter
Top Products
Part No 1130250 3 Installing Front Riggings on the At’m
Installing/Removing the Front Rigging Assembly
NOTE: For this procedure, refer to FIGURE 2.
Installing
1. Turn the front rigging assembly to the side (open footrest is perpendicular to
the wheelchair).
2. Insert the mounting pin on the front rigging assembly into the front rigging
support bracket.
3. Rotate the front rigging assembly towards the inside of the wheelchair until it
locks into place.
NOTE: The footplate will be facing the inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3 for the other front rigging assembly.
5. If necessary, adjust the footrest height. Refer to Adjusting Footrest Height on
page 4.
Removing
1. Push the front rigging release lever inward while rotating the front rigging
assembly outward.
2. Lift the front rigging assembly out of the front rigging support bracket.
3. Repeat STEPS 1-2 for the other front rigging assembly, if necessary.
FIGURE 2 Installing/Removing the Front Rigging Assembly
Seat Frame Tube
Footrest
Mounting Pin
Front Rigging
Assembly
Front Rigging
Support Bracket
Front Rigging
Release Lever
Outside of
Wheelchair
Inside of
Wheelchair