Filter
Top Products
LEG EXTENSIONS AND Part No. 1089633
WHEELED WALKER ACCESSORIES
4
INSTALLING THE GLIDE TIP (FIGURE 3)
NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY of this instruction sheet.
1. Depress the snap buttons on the walker
frame to remove the rear leg extension from
the walker.
2. Firmly grasp the leg extension and perform
one of the following:
A. Remove the EXISTING glide tip from the
leg extension.
B. Remove the rubber tip from the leg
extension.
NOTE: When properly installed, the tube edge will rest
inside the top edge of the new glide tip. If the tube edge
is visible, the tip is not properly installed.
3. Insert the NEW glide tip firmly into the leg
extension.
4. Ensure the NEW glide tip is properly installed
as shown in DETAIL "A" of FIGURE 3. If
necessary, tap new glide tip into position.
5. Depress the snap button and install the leg
extension with NEW glide tip onto the walker
frame leg. Ensure that the snap button of each
leg fully protrudes through the desired
adjustment hole and legs are adjusted so the
walker sits level.
6. Repeat STEPS 1-5 on remaining rear leg
extension.
FIGURE 2 - INSTALLING REAR LEG EXTENSION OPTIONS
MODEL NOS.
6264 AND 6265
MODEL NO. 6266
Adjustment
Holes
MODEL NOS.
6263 AND 6274
Sure
Glide
Adjustment
Holes
5. Repeat STEP 4 for remaining wheel attachment/leg extension.
6. Ensure that the snap button of each leg fully protrudes through the desired adjustment
hole and legs are adjusted so the walker sits level.
FIGURE 3 - INSTALLING
THE GLIDE TIP
Glide Tip
Properly
Installed
Glide Tip
Improperly
Installed
DETAIL "A"
Walker
Frame Leg
Snap
Button
Leg Tube
Glide Tip
Brake
with
Wheel
Adjustment
Holes