Filter
Top Products
3
Part No. 1089633 LEG EXTENSIONS AND
WHEELED WALKER ACCESSORIES
3. Repeat STEP 2 for remaining FRONT leg.
4. Adjust the wheel attachment/leg extension to one (1) of the adjustment holes.
5. Perform one (1) of the following:
A. Install the REAR leg extension options, if necessary. Refer to
INSTALLING REAR
LEG EXTENSION OPTIONS in this instruction sheet.
B. Remove rear rubber tips and replace with glide tips included. Refer to
INSTALLING
THE GLIDE TIP in this instruction sheet.
NOTE: When using 10-inch REAR leg extensions, the adjustment ranges are reduced on Model Nos.
6273 and 6267.
6. Ensure that the snap button of each leg fully protrudes through the desired adjustment
hole and legs are adjusted so the walker is level.
INSTALLING REAR LEG EXTENSION OPTIONS (FIGURE 2)
NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY of this instruction sheet.
1. Depress the snap buttons to remove the two (2) EXISTING REAR leg extensions from
the walker.
NOTE: The REAR leg extensions will not be reassembled to the walker when using the REAR wheel
attachments.
2. Depress the snap button on the walker frame and install the NEW wheel attachment/leg
extension onto REAR leg of the walker.
3. Repeat STEP 2 for remaining REAR leg.
4. Adjust the wheel attachment/leg extension to one (1) of the adjustment holes.
FIGURE 1 - INSTALLING WHEEL ATTACHMENTS/LEG EXTENSIONS
LEG
EXTENSION
MODEL NOS. 6273 AND 6267
SWIVEL WHEEL
ATTACHMENT
Adjustment
Holes
MODEL NO. 6275
Walker
Frame
FRONT REAR
MODEL NOS. 6270 AND 6271
Snap Button
FIXED WHEEL ATTACHMENT
Leg Tube
Washers
Wheel
Locknut
Hex Screw
Bushing