Filter
Top Products
4
OPENING/FOLDING THE WALKER (FIGURE 1)
NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY in
this instruction sheet.
1. Press the release button to unlock the lock bar.
2. Grasping the lock bar, pull until the walker is fully unfolded and an audible
"click" is heard.
3. If necessary, unfold the handles by performing the following:
A. Grasp the handle and pull towards side of the walker frame.
B. Ensure both snap buttons fully protrude through both height adjustment holes.
C. Repeat STEPS A-B on remaining handle.
4. Ensure both handles are even and at the correct height. Refer to
ADJUST-
ING THE HANDLE BARS in this instruction sheet.
5. Reverse STEPS 1-3 to fold the walker.
SAFETY SUMMARY (continued)
FOLDING/ASSEMBLY WARNINGS
After unfolding or assembling walker, ensure that walker is securely locked
in OPEN position and level to the ground BEFORE using.
DO NOT hang anything on either the left or right side frames or the left
and right handle bars. This will cause side frames or handle bars to bend
downward and prevent walker from locking into place when fully
opened. This may also cause walker to tip, resulting in injury or damage.
INSTALLATION WARNINGS
Ensure ALL handle snap buttons fully protrude through adjustment holes
of each front frame tube. This ensures that the handles are securely
locked in position.
The handles should be adjusted so the walker is level.
Always test to see that the walker and attachments are properly and
securely locked in place BEFORE using.