Filter
Top Products
A.B.S. Curved Back w/o Attaching Hardware
Tilt Only (2GT)
(After 10/31/00)
NOTE: Overall back height is calculated by measuring from the seat pan surface to the top of the back
pan. Back pan material height can be calculated by subtracting 3-3/4" from the overall back height listed.
Material height listed is rounded off to the nearest whole number.
NOTE: After 10/31/00 spacing between the seat pan and the lower side of the back pan was decreased 3"
by adding 3" to the back pan material. Overall back height did not change.
NOTE: A.B.S. curved backs do not retrofit to the 7/8" round canes. Key slotted back canes and back
attaching hardware must be ordered.
NOTE: Hook Fastener Adhesive Kit must be ordered when a Back Pan or Back Assembly is requested.
This will allow the Loop Fastener Adhesive on the Back Cover to attach properly.
Item
Number
Part Number
DescriptionNote
Quantity Per
Package Assembly
See Chart #1 Back Pan 16" Wide - 19" Wide 1 11
See Chart #1 Back Pan 20" Wide - 22" Wide 1 11
See Chart #2 Back Cushion Assembly 16" Wide - 19" Wide 1 12
See Chart #2 Back Cushion Assembly 20" Wide - 22" Wide 1 12
See Chart #3 Back Assembly w/o Hardware 16" Wide - 19"
Wide
1 13
See Chart #3 Back Assembly w/o Hardware 20" Wide - 22"
Wide
1 13
1125723 Kit, Hook Fastener w/ Adhesive Back 1 1A
A - Not Shown. Hook Fastener Adhesive Kit is used to attach the Back Cover to the Back Pan and must be ordered when a
new Back Pan or Back Assembly is requested.
NOTE:
62
To order call toll free 1-800-333-6900, or www.invacare.com
Form No.
99-150