Filter
Top Products
I-Transia™
5. Open the legs of the second vertical pole module.
6. Raise the second vertical pole module B.
7. Lift the other end of the top bracket and rail module C and
mount it on top of the vertical pole module C.
The top bracket must be flush with the mark on the
vertical pole G.
8. Lock the top bracket C to the vertical pole B with the locking
arm D.
9. Lock the rail module E to the top bracket module C with the
two yellow thumb screws F.
3.4 Installing the Hoist
WARNING!
– Before installing the hoist, read and understand the
hoist user manual, part number 1183377.
1. Loosen the two screws H securing the end stop I to the rail E.
2. Remove the end stop from the rail.
It may be necessary to tilt the end stop as you remove
it from the rail.
If the end stop cannot be tilted and removed, remove the
two screws from the end stop.
3. Insert the hoist J into the rail E.
4. Mount the end stop I, making sure that the spring pin K is
positioned in the pre-drilled hole L.
The end stop may need to be tilted to enable mounting.
If the screws were removed while removing the end stop,
install the two screws after the end stop is in position.
4
1183379A