Filter
Top Products
7
Installing the Seat (FIGURE 10)
WARNING
To prevent pinching injury between seat
back and motor shroud when removing/
installing the seat, DO NOT grasp seat any-
where other than at the recess at the top,
the opening at the bottom of the seat or
the lip at the top of the seat.
To prevent frame from tipping when re-
moving seat, either suction the frame to
the floor or place one foot on the frame
base when removing/installing the seat.
CAUTION
The bath lift seat MUST be installed from
the uppermost lifting position, otherwise,
damage to the unit may occur.
DO NOT grasp seat by side flaps to avoid
damage to the bath lift or the bathtub.
1. Secure the frame to the floor with the suction cups or by
standing on the frame base.
2. Grasp the handgrip on the battery pack and push
downwards to install it onto the motor shroud.
FIGURE 9 - INSTALLING THE BATH LIFT INTO THE BATHTUB
3. Press the UP button on the pendant to raise the
bath lift to the uppermost position.
4. Grasp the handgrip on the battery pack and pull
upwards to remove it from the motor shroud.
5. Lower the seat onto the frame, ensuring that the slide
block on the back of the chair slides down the two (2)
grooves on the frame as shown in FIGURE 10.
NOTE: The seat MUST be lowered onto the frame
until the spring loaded chair release button locks in
place and an audible "click" is heard.
Down
Up
Pendant
Frame
FIGURE 10 - INSTALLING THE SEAT
LOWER
SEAT
Slide
Block
Groove
Seat
Spring Loaded Chair
Release Button
Recess
Seat
Entry/Exit
Side Flap
Position of Line
on Side Flap
Seat
Inside Edge
of Bathtub
PROPER POSITIONING OF
ENTRY/EXIT SIDE FLAP
Side Flap
Hinge
FRONT VIEW - STEPS 5C-5D
Side Flaps
Seat
Frame
Suction Cups
and Pads Flat
on Bottom of
bathtub
Bathtub
SIDE VIEW - STEPS 5A & 6
PRESS DOWN ON
SUCTION CUP
Back of
the
Bathtub
Frame
Suction
Cup
Rubber Pad
Front of the
Bathtub
(fixture end)
Suction
Cup
Loop
é
Battery Pack
Motor
Shroud
DETAIL "G"
STEP 5C
STEP 1 STEP 2
PULL UP
TO
REMOVE