Filter
Top Products
4
WARNING
Lifting column MUST be in lowest position
BEFORE installing frame to prevent tipping.
The frame should be placed into an EMPTY
bathtub.
1. Raise the bath lift all the way up by pressing the
UP (é) button on the pendant (FIGURE 16).
NOTE: The lift will automatically stop at the top and
bottom limits if UP/DOWN buttons are not released.
Reinstall Seat onto Bath Lift Frame
(FIGURES 16-18)
NOTE: If necessary, reinstall the battery pack on the frame.
Back of
the
Bathtub
Frame
Suction Cup
Rubber Pad
Front of the Bathtub
(fixture end)
FIGURE 15 - INSTALLING THE BATH LIFT INTO
THE BATH TUB
FIGURE 16 - RAISING THE BATH LIFT
Pendant
Up
2. Remove the battery pack by grasping the handgrip
on battery pack and pull upwards (FIGURE 17).
FIGURE 17 - REMOVING THE BATTERY PACK
PULL UP TO
REMOVE
é
Battery
Pack
Frame
3. Lower the seat onto the frame, ensuring that the slide
block on the back of the chair slides down the two (2)
grooves on the frame (FIGURE 18).
NOTE: The seat MUST be lowered onto the frame until
the spring loaded chair release button locks in place and
an audible "click" is heard.
4. Position the Bath Lift in the bath tub, refer to POSI-
TIONING THE BATH LIFT FRAME IN BATH TUB in
this Instruction Sheet
Frame
FIGURE 18 - INSTALLING THE SEAT
Slide
Block
Groove
Seat
LOWER
SEAT