Filter
Top Products
1
NOTE: Check all parts for shipping damage before
using. In case of damage, DO NOT use. Contact the
Dealer/Carrier for further instructions.
SAFETY SUMMARY
The following recommendations are made for the
safe installation of the Mounting Kit on the Reli-
ant Bath Lift (RBL250).
GENERAL WARNING
DO NOT assemble or use this kit without
first reading and understanding this in-
struction sheet. If you are unable to un-
derstand the Warnings, Cautions or Instruc-
tions in this Instruction Sheet and in the
Owner's Operating and Maintenance
Manual (Part No. 1081003) provided with
the Bath Lift. contact a healthcare pro-
fessional, dealer or technical personnel
before attempting to install this kit, other-
wise, injury or damage may occur.
REPLACING THE BATH LIFT
MOUNTS
Removing the Bath Lift Seat (FIGURES 1-7)
NOTE: Refer to the GENERAL WARNINGS in the
SAFTY SUMMARY of this Instruction Sheet.
1. Raise the Bath Lift seat by pressing the UP (é) but-
ton on the pendant (FIGURE 1).
NOTE: The lift will automatically stop at the top and
bottom limits if UP/DOWN buttons are not released.
2. Remove the battery pack by grasping the handgrip
on battery pack and pulling upwards (FIGURE 2).
FIGURE 2 - REMOVING THE BATTERY PACK
DESCRIPTION QTY
Suction Cups 2
End Plugs 4
Locking Clips 2
Rubber Pads 2
Instruction Sheet 1
This kit contains the following:
FIGURE 3 - RELEASING THE SEAT
WARNING
To prevent pinching injury between seat
back and motor shroud when removing/
installing the seat, DO NOT grasp seat any-
where other than at the recess at the top
(FIGURE 3), the opening at the bottom of
the seat or the lip where the battery pack
was.
CAUTION
DO NOT remove the seat until the bath Lift
is raised to the upper limit. Otherwise dam-
age may occur.
3. To release the seat, press and hold the spring loaded
chair release button (FIGURE 3).
Spring Loaded
Chair Release
Button
Recess
Seat
4. While holding the spring loaded chair release but-
ton with one hand, grasp the seat bottom firmly with
your other hand.
5. Lift the seat up until the slide block comes free of the
grooves on the Bath Lift frame to remove the seat
from the frame (FIGURE 4).
FIGURE 1 - RAISING THE BATH LIFT
Pendant
Up
INSTALLATION WARNINGS
When installing or removing the Battery
pack ALWAYS hold the battery pack firmly,
otherwise injury or damage may result.
To prevent frame from tipping when raising
or lowering the seat, either suction the frame
to the floor or place one foot on the frame
base when removing/installing the seat.
PULL UP TO
REMOVE
é
Battery Pack
Frame
Handgrip
Motor Shroud
Battery Pack
Reliant Bath Lift (RBL250) Mounting Kit
Assembly, Installation and Operating Instructions
Kit No. 1085143