Filter
Top Products
HOOK-ON TROLLEY PARTS
PART NUMBER FOR ORDERING
Trolley Assembly
for operation on 4” to 12” I-Beam having flanges 2.66” (68 mm) to 5.00”
(127 mm) wide
for ML25K and ML50K . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
for operation on 5” to 12” I-Beam having flanges 3.00” (76 mm) to 5.00”
(127 mm) wide
for MLl00K.............................................
for operation on Flat Tread Monorail
for ML25K and ML50K . . . . . . . . . . . . . . . . . . . . . . . .
for MLl00K.............................................
Trolley Wheel (4)
for Hook-On Trolley No. MRl0-7927 . . . . . . . . . . . . . . . . . . . . . . . . . .
for Hook-On Trolley No. MR20-7928 . . . . . . . . . . . . . . . . . . . . . . . . .
for Hook-On Trolley No. MRl0-7927T. . . . . . . . . . . . . . . . . . . . .
for Hook-On Trolley No. MR20-7928T . . . . . . . . . . . . . . . . . . . . . . . . . . .
Semi-Rigid Trolley Adapter
for ML25K and ML50K . . . . . . . . . , . . . . . . . . . . . . . . . . . . . . . . . . . .
for MLl00K.............................................
MRl0-7927
MR20-7928
MRl0-7927T
MR20-7928T
MRl0-691
MR20-691
MRl0-691T
MR20-691T
MRl0-852
ML20-852
INSTALLATION INSTRUCTIONS FOR FABRIC CHAIN CONTAINER KITS
ML50K-K479-17 AND ML50K-K749-45
WARNING: DISCONNECT THE HOIST FROM THE AIR SUPPLY BEFORE INSTALLING A CHAIN CONTAINER KIT.
Refer to illustrations on Page 28 and install a Fabric Chain Container as follows:
1. Insert a Container Bolt (270) through the boss on the Hoist housing and into the Brackets (266 and 267). Retain the
Container with the Container Bolt Nuts (271). Note: If the Container is to be allowed to swing outward, tighten the
Nuts to within one turn of being fully tight. This will allow the Container to swing away from a load.
2. Apply the Balance Chain (272) to the Container and Hoist using S-Hooks (273). Adjust the length of the Chain to pre-
vent the load chain from rubbing on the Container.
27