Filter
Top Products
CHAIN REPLACEMENT (Continued)
For Single Line Hoists, Method 1
1. Remove the Brake Spring and Piston Housing, Brake Discs and Brake Plates to expose the Brake Driver.
2. Engage the first link of chain in a pocket of the pocket wheel
FLAT SIDE DOWN.
The weld on the second link must
face away from the pocket wheel.
(Dwg. TPD571)
3. Rotate the Brake Driver by hand to thread the chain through the Hoist.
4. Keep the chain straight and do not twist it. Attach the free end of the chain using the chain anchor bolt, washers and
spacer. Clean the brake parts and inspect them for excessive wear before assembling.
(Dwg. TPD572)