Filter
Top Products
English – 9
ASSEMBLY
Assembling the stand
1 Drill holes (15 mm) in the floor or in the wall and knock in
the expander bolts.
2 Screw the base plate tight. Check carefully that the
expander is secured correctly.
• The drill column is mounted on the base plate’s angle
bracket. Fasten the locking screw with a 24 mm spanner.
The drill column can be variably adjusted through 360°. With
help of the locking screw for the pivot function, the column can
be adjusted in four fixed
3 The column can be angled by loosening the locking
screws with a 24 mm spanner.
• To angle the column parallel to the base plate, loosen the
screw on the positioning ring.
Assembly of drill motor
1 Lock the feeder housing on the drill column with the lock
handle.
2 Loosen the locking screw for the locking clamp.
3 Always remove the drill bit before the motor is mounted or
dismounted.
4 Mount suitable drilling machine on the quick mounting.
Mount the quick mounting and drilling machine in the track
on the locking clamp.
5 Fasten the locking clamp with the locking screw.
6 Set the feed lever to a suitable transmission.
7 Unlock the feeder housing.
8 Start drilling. See manual for selected drilling machine.
The slide function on the feeder housing is factory set. To
adjust the slide function, see maintenance.