Filter
Top Products
23 24
POTENTIAL FOR
ELECTROMAGNETIC INTERFERENCE
To avoid inaccurate results caused by
electromagnetic interference between electrical
and electronic equipments, do not use the device
near a cell phone or microwave oven.
TROUBLESHOOTING
If any abnormality arises during use, please check the following points:
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassemble
or attempt to repair the unit by yourself. Contact
information for HoMedics Consumer Relations Department
can be found on the warranty page (See page 26).
SYMPTOMS
POSSIBLE
CAUSES
CORRECTION
Unit does not
turn on when the
START/STOP
button is pushed.
Batteries have
run down.
Replace them
with two new AAA
alkaline batteries.
Battery polarities
have been positioned
incorrectly.
Re-insert the
batteries in the
correct positions.
EE measurement
error symbol shown
on display or the
blood pressure
value is displayed
excessively low
(or high).
Cuff has been placed
incorrectly.
Wrap the cuff
properly so that it is
positioned correctly.
Did you talk or move
during
measurement?
Measure again.
Keep wrist steady
during measurement.
Shaking of the wrist
with the cuff on.
E1 error symbol
shown on display
Air circuit
abnormality.
Measure again.
E2 error symbol
shown on display
Inflation pressure
exceeding 300 mmHg.
Switch the unit off,
then measure again.
E3 error symbol
shown on display
Error determining
measurement data.
Measure again.
BPW-040_A.indd 25-26BPW-040_A.indd 25-26 12/22/09 12:37 PM12/22/09 12:37 PM