1615
5. Position the red area of the cuff on the inside of
your left arm with the artery symbol ( ) over the
main artery.
6. To secure the cuff, pull the end toward you,
wrap it over the cuff, then press the hook and loop
closure together.
Note: If it is not possible to fit the cuff to your left
arm, it can also be placed on your right arm.
However, all measurements should be made
using the same arm.
Main
Artery
Pull end toward you, then
wrap over cuff
2. Unwrap the arm cuff. It is pre-formed for easier use.
3. Remove tight fitting clothing from around your upper
left arm. Wrap the cuff around your upper left arm as
shown below. The rubber tube should point in the
direction of your hand. The bottom edge of the cuff
should be 0.8”~1.2” (2~3 cm) above your elbow
with the tube positioned over the middle of your arm.
4. Locate the main artery by pressing with two
fingers approximately 1” (2 cm) above the bend of
your elbow on the inside of your left arm. Identify
where the pulse can be felt the strongest. This is
your main artery.
BPA-101IB_ENGSP.qxd 10/24/05 11:00 AM Page 15