Filter
Top Products
How to use
It is recommended to use the shaver at an ambient temperature of 5°C to 35°C.
Use or storage at a temperature below the recommended temperature may disable the shaver or
cause a reduced number of operating times.
For initial use, trim while lightly applying the shaver to skin.
How to shave with the foil
Check that there is no breakage and deformation of the foil before use.
(Cause of damage to skin)
Do not shave with the trimming blade down. (Cause of damage to skin)
Never press it strongly to the skin.
(Cause of damage to skin especially lips and cause of damage to the foil)
Never shave with only a part of the foil or bring fingers or nails into contact with the foil during use.
(Cause of damage to the foil resulting in damage to skin)
Use carefully if you have acne or abrasions on skin. (Breakage causes damage to skin)
1. Remove the cap and turn "ON" the switch..
The remaining battery level indicator lamp or charge requesting lamp lights.
If the remaining battery level indicator lamp "EMP" or charge requesting lamp flashes,
this indicates that charging is required. Charge by connecting the power adaptor to
the main body or use the shaver as it is with alternating current.
Never touch the switch during operation.
2. Shave with the trimming blade up so as to lightly glide the shaver against the flow of
beard in the arrow direction. (Fig.7)
How to shave delicately
(1) Stretch the skin by hand, and raise beard.
(2) Press the blade surface perpendicular to skin. (Fig.8)
(3) Lightly press the shaver and slowly shave upward.
When shaving a long grown beard which is difficult to shave by the foil
Cut long grown beard short with the trimming blade, and finish with the foil.
Caution
Never operate the shaver continuously for 20 minutes or more. The shaver automatically
stops in approximately 20 minutes as a circuit protector. You can use it by turning on again.
3. After use, turn "OFF" the switch and put on the cap.
The remaining battery level indicator lamp goes out in three seconds.
Direct the trimming blade upward.
Mode selection
By pressing the selector button, the auto mode, power mode, or normal
mode can be selected. After the normal mode, it returns to the auto mode. (Fig.9)
Auto Powerful Normal Select the mode by pressing the selector button.
Auto mode (Auto)
The auto mode operates to automatically control the power mode and normal mode depending
on beard thickness. (Fig.10)
The auto lamp "lights (green)."
The mode indicator flashes (blue)."
Caution
If a large amount of beard clippings accumulate in the blade or oil on the blade face runs out, the
auto mode may not operate.
Use in auto mode
When the remaining battery level indicator lamp "EMP" has started flashing, the auto mode is
reset, the auto lamp is turned off, and the mode changes to the power mode.
Mode indicator “flashes (blue).” Auto lamp “lights (green).”