Filter
Top Products
8
Section 4 - Operating the AL200 Lift continued
Trunk Applications
• If preparations needed to be made to secure the scooter or chair for transport, such as parking brakes or wheel
chocks, do these now. Dealers should instruct operators on how, if necessary, to secure the scooter or chair for
transport. Close the trunk and you are ready to go.
Unloading Your Scooter or Power Chair —Trunk Applications
• Undo any preparations made to secure the scooter or power chair for transport.
• To assemble your lift, begin by inserting the Post into the Base mounted on the floor. Next, slide the Lifting Arm
onto the Post.
• Plug in the Hand Control.
• By pressing the DOWN button on the Hand Control harness, run the Strap Hook down until it is slightly lower
than the docking device on the scooter.
• Attach the Strap Hook to the docking device on the scooter or chair and remove any play in the strap by pressing
the UP button on the Hand Control until tension is felt.
Caution: Ensure that the Lifting Strap is secure and taught and that it points straight down. Failure to do so
could result in the scooter or chair swinging toward the vehicle or operator.
• Raise the scooter or power chair using the UP button until the scooter or chair is just above the trunk lip.
Caution: Stop lifting before the Strap Hook contacts the Strap Roller mounted on the Lifting Arm. Contact
will result in damage to the lift. A properly adjusted and operated lift will avoid this.
• Swing the scooter or chair out of the vehicle, carefully ensuring that the scooter does not contact the vehicle.
• With the scooter or chair positioned away from the vehicle, lower the lift using the DOWN button. Continue low-
ering the lift slightly beyond the scooter or chair touching the ground to allow removal of the Strap Hook from the
docking device on the scooter.
• To disassemble the lift, first raise the Lifting Strap until the freed Strap Hook is about an inch away from the Lift-
ing Arm. Unplug the Hand Control harness from both the Vehicle Harness and the Lifting Arm.
• Pull the Lifting Arm off of the Post and lay it on the floor of the trunk. Then pull the Post out of the Base using the
handle and set it down with the Lifting Arm.
Replace anything removed from the scooter or chair for loading purposes. Close the trunk and you are ready to go.