Filter
Top Products
SKU 96513/14 For technical questions, please call 1-800-444-3353. Page 6
4- Wheel ATV Unloading
WARNING!
THIS RAMP IS FOR USE WITH 2 OR 4-WHEELED ATV’S ONLY. DO NOT USE •
THIS RAMP TO UNLOAD 3-WHEELED VEHICLES.
DO NOT USE THIS RAMP TO UNLOAD ANY VEHICLE THAT WEIGHS MORE •
THAN 1000 LB.
DO NOT USE THIS RAMP TO UNLOAD ANY VEHICLE THAT IS WIDER THAN THE •
RAMPS, ADJUST THE RAMPS BY MOVING THE ATV CLOSE TO THE HAULING
VEHICLE AND ADJUSTING THE WIDTH BEFORE PUTTING ANY WEIGHT ON
THE TRI-FOLD RAMPS.
DO NOT USE THIS RAMP TO UNLOAD ANY VEHICLE THAT IS CARRYING GEAR •
ON ITS RACKS.
DO NOT USE THIS RAMP IF THE TAILGATE ON THE VEHICLE BEING UNLOADED •
IS HIGHER THAN HALF THE RAMP’S LENGTH.
WARNING! All persons not involved in the unloading process must stand clear of the
loading Ramp and truck.
WARNING! RIDING AN ATV WHILE UNLOADING IS
DANGEROUS AND SHOULD NOT BE ATTEMPTED.
Have a qualied adult assistant monitor the Ramp tongue for slippage on the tailgate.1.
Setup the ramp on the truck bed as explained under “Operation”, on page 4. Remove 2.
all tie down straps and securing equipment from the ATV. WARNING! BE SURE THE
4-WHEELED ATV IS CENTERED ON RAMP.
While staying off the ATV, start the engine, disengage the parking brake, put the transmis-3.
sion into reverse, and make sure the wheels are in a straight line with the ramp. While
holding the brake, position yourself on the truck bed in front of the ATV.
Release the brake and push on the ATV to get it started down the ramp. Allow the ATV 4.
to roll down naturally, do not attempt to steer it or apply the brakes. If it stops while on
the ramp, gently give it throttle to back it off the ramp.