Filter
Top Products
Page 7SKU 47082
For technical questions, please call 1-800-444-3353.
To cut the sideburns, change Comb to #1 or #2. To produce a clean, straight line 13.
for the sideburns, reverse the Clipper by turning the bottom side upwards (see
diagram 7).
Press the Clipper at a right angle to the head, with the tips of the blades lightly 14.
touching the skin and work downwards to obtain a clean, razor-like cut.
Comb through hair to check for uneven strands and ensure an even cut.15.
Short tapered styles
Starting with Comb #4, cut from the back of the head to the top of the head. Hold 1.
the attachment comb at against the head and slowly move the Clippers through
the hair (see diagram 8).
Use the same procedure from the lower side of the head to the upper side of the 2.
head (as illustrated).
Cut the hair against the direction in which it grows, from the front to the top of the 3.
head, and then level the cut with the sides.
To create a “at top” look, the hair must be cut over the top of a at comb rather 4.
than with an attachment Comb.
Use the closer cutting attachments to taper the hair down to the neckline, as 5.
desired.
INSPECTION, MAINTENANCE, AND CLEANING
Make sure the Power Switch of the clipper is in its “OFF”
position and that the clipper is unplugged from its electrical
outlet before performing any inspection, maintenance, or cleaning
procedures.
BEFORE EACH USE, inspect the general condition of the clipper. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts, dam-
aged electrical wiring, and any other condition that may affect its safe operation. If
abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.