Filter
Top Products
Page 5SKU 47082
For technical questions, please call 1-800-444-3353.
Before turning the Clipper off, rapidly move the Blade Lever from close cut to •
longer cut twice. This will clear trimmings from the Clipper.
Cutting Hair
Attachment Comb #1 leaves 3mm (1/8 inch) hair length.
Attachment Comb #2 leaves 6mm (1/4 inch) hair length.
Attachment Comb #3 leaves 9mm (3/8 inch) hair length.
Attachment Comb #4 leaves 12mm (1/2 inch) hair length.
The Comb’s sizes are marked on the outside middle surface. To apply a Comb, •
hold it with the teeth upwards and slide it onto and along the Clipper blade until
the front of the comb is seated rmly against the clipper blade.
Inspect the Clipper, making sure it is free of oil between the cutting blade teeth. 1.
Turn the unit on to distribute the oil and to make sure it runs smoothly. Wipe off
any excess oil. This should be done after each use. Untwist the power cord to
avoid tangling.
For good visibility and easy access, seat the person getting their hair cut with their 2.
head at eye level of the person cutting the hair.
Comb hair so it is tangle free and arrange in style desired.3.
Place a towel around the neck and shoulders of the person getting the haircut.4.
Attach Comb #1 or #25.
Leave hair dry to more easily control the amount of hair being cut.•
Cut hair slowly and in short strokes.•
Only cut a little hair at a time, more can be trimmed later if necessary.•
Comb hair frequently back into the intended style.•
Hold the Clipper, cutting edge up, and begin the haircut starting at the middle of 6.
the base of the neck (see diagram 1).
With the Comb teeth pointed upwards, lift the Clipper upwards and outwards 7.
through the hair, trimming a small amount at a time.
As you cut, lift the Clipper head towards you while continuing to cut the back area 8.
from the bottom of the neck to the top of the ears.