Filter
Top Products
Model T10008 2000 Kg Digital Crane Scale-8-
Scale Battery
The scale will automatically display the
current scale battery voltage when you
turn the scale ON and OFF. To check the
voltage during use, press the MR button
on the remote control and the screen will
display SHIFT. Press the F1 button and the
screen will display U X.XX. To return to the
main display, press MR again.
When the battery voltage is lower than
U 5.80, the screen will flash to alert you.
The scale will continue to display for
approximately one minute longer and then
turn OFF automatically. The scale will
need to be charged before further use.
The Model T10008 has an easy to remove
battery for convenient charging. Remove
the two outer cap screws from the back of
the scale body. Slide the battery out and
unplug the wire clip connection, as shown
in Figure 6.
Hold Function
When the load has been added to the
scale, wait until the STEADY light goes off,
signifying that the load is stable (Figure 4).
If you would like the weight value to remain
on the screen, press the HOLD button on
the remote control and the Hold LED will
flash on the display (Figure 4). To clear the
screen, press the HOLD button again.
Advance Tare Weight
To input a known tare weight before weigh-
ing an item, press MR and the screen
will display SHIFT. Press TARE, and the
screen will display 00000. To input the
desired weight, scroll to the right by press-
ing the right arrow (TARE) button on
the remote control until you come to the
number that you would like to change. To
increase the number from zero, press the
left button (
�
) on the remote control.
To submit the tare amount, press MR and
the TARE light will come on the scale,
automatically deducting the imputed tare
weight. The tare weight will stay the same
until the scale is turned OFF.
Clear Function
To clear, press the CLEAR button and the
screen will flash CLr. If you would like to
approve the clear command, press the MR
button and the screen will display "End",
and return to the main screen. If you would
like to cancel the clear command, press
the CLEAR button again and the display
will return to the main screen.
Figure 6. Unplugging the battery.
To recharge the battery:
1. Turn the scale OFF.
2. Connect the supplied adapter into the
socket located in the back of the scale,
then into a grounded 110V outlet. The
light turns orange while charging and
turns red when charging is complete.
Note: The battery should re-charge for
at least 8 hours.