Filter
Top Products
2D:4>6C:42?#65:42=&C@5F4ED25:G:D:@?@762=E9&C@5F4ED?4K#2EC:IK(,#2?F2= &
ssembly - standard wallsaver
(with optional trapeze positioning)
A
1. The Matrix II 709 standard
wireform wallsaver is easily
attached to the head-end of
caster carriage. Begin by
positioning the wallsaver
(#2) on the head end with
the exposed ends (with flat
insert tabs) facing the foot-
end of the bed.
2. From the inside, locate the
bottom last hole in the carriage
bracket on both sides of the
bed. Holding the wallsaver in a
45° position as shown, squeeze its
sides inward toward center and
insert the ends of the wallsaver
into the bracket holes. (See Detail A)
3. Carefully lower the wallsaver downward
until it rests on the floor. The flat insert
tab will turn within the bracket hole, locking
the wallsaver into place. (See Detail B).
4. The position of the wallsaver is very
important on the Matrix II bed. It has
been designed so that the bed will be
kept a safe distance from the wall
when raising or lowering the bed,
thus preventing damage to the bed
or resident/facility walls.
Item # Quantity Part # Description
1 Reference 999-0807-955G
Standard Caster Carriage Assembly
(Also works on Locking Carriage Assembly 999-0807-958G)
2 1 999-0779-180 Standard Wireform Wallsaver - 76”, 80”, or 84”
NO SPECIAL Tools REQUIRED
"**
$)(*
)%***
)&("""
-*)"%*$
(((!*
"**"%!)$*%
(((!*
/*+($$*
&(&$+"(
%$*)
$)%"
"*$)(**
-""),(
&%)*%$%(*(
&0
)*$(
-""),(
&%)*%$
(((!*
%(M