Filter
Top Products
Installing the Optional Seat Assembly:
Locate all the seat assembly components and have them at
hand to begin the installation of the seat assembly (Fig 5).
- Remove the seat-post locking collar from the main seat-post
tube to allow insertion of the tube through the base frame
from the bottom up (fig 6).
- Flip the base over to the side and insert the main seat-post
tube. Make sure that the adjustment holes face the left
wheel, otherwise you may end up with the
basket brackets facing the front of the
scooter, which is not appropriate (Fig 7).
Fasten the 4 Allen bolts to the base frame
and tighten them very well using the Allen
key provided. Make sure that you do not
forget to slide a pressure nut into every bolt
before affixing it to the base frame.
- Flip the base frame over and re-install the
locking seat-post locking collar. Do not tighten yet. This will have to be done after
you have inserted the seat assembly and once you select your desired seat height.
- Making sure that the basket brackets
face towards the rear of the seat
(backrest), insert the adjustable,
removable seat-post tube into the seat
base receiver. Tighten the nut and bolt
(Fig 8).
- Insert the seat assembly onto the
receiver seat-post (Fig 9) and select your
desired seat height.
- DO NOT forget to lock the seat-post collar (Fig 10) now!
You are now ready to couple the tiller and the base frame
together.
Seat
Main
Seat-Post
Page 8
Fig 5
Fig 6
Fig 7
Fig 8
Fig 9
Fig10