Filter
Top Products
Assembly Instructions
Your Stand N Ride is shipped in two boxes: 1 containing the tiller and 1 containing the
base frame.
After you have removed the Stand N Ride components from the protective packaging,
you are ready to set up your scooter for riding by following these steps:
Tiller Assembly:
- Loosen the tiller height lock to allow for the
insertion of the upper portion of the tiller/handle
bar (Fig 1 and Fig 2).
- Making sure that the main wire harness and the
brake cable are not caught by the tubing, insert the
upper tiller section and slide it to your desired
height. Fasten the center guide screw so the tiller
stays centered and then lock it in place by tightening the
collar lock with the Allen key provided. You can always
loosen it and re-adjust the height if your initial height is
not comfortable.
- Make sure that the tiller is centered and securely fastened
before you move to the next step.
Base Frame Assembly:
Remove the battery pack from the main base component to
ease the task of installing the wheels.
- Slide a washer on the rear wheel shaft (Fig 3).
- Now install the wheel followed by the other washer and the
Nylock nut. Tighten it by hand.
- Repeat the process on the other side for the remaining wheel.
- Using a 22 mm wrench (or a 7/8 wrench), tighten the nut to
secure the wheels in place. DO NOT over-tighten the nut and
make sure that the wheel turns freely but is securely fastened
to the shaft (Fig 4).
- Repeat the process for the other side.
Page 7
Fig 1
Fig 2
Fig 3
Fig 4